Category: DesignJet 430, 450C, 455CA, 488CA

There are a multitude of errors that can be traced to a dirty or damaged encoder strip.When diagnosing, troubleshooting and repairing these errors first you have to become accustomed to the errors that DesignJet plotters give when they cannot locate the carriage assembly in its travel path more »
When your inkjet type printer displays a Paper Jam error and you cannot see any paper in the path, anywhere. You may have a small torn away scrap of paper somewhere in the path. This usually occurs after you have experienced a feed problem and had to manually pull the paper out of the printer.Use caution whenever you must manually (and forcefully) yank out a piece of jammed paper. Here is the quick and easy way to clear out any debris hiding inside. more »
After replacing the carriage belt on a DesignJet 400 series plotter an Error code of K L M is displayed on the front panel... more »
Adjusting the distance is important if the carriage is too high you will get unwanted spray around the ink dots, or over spray and your vertical lines will not be straight. If the carriage is too low you will get you will get ink smears or even have the carriage scrape the paper. more »
November 2017
Sun Mon Tue Wed Thu Fri Sat
 << <   > >>
      1 2 3 4
5 6 7 8 9 10 11
12 13 14 15 16 17 18
19 20 21 22 23 24 25
26 27 28 29 30    
Do it yourself repair information for your HP DesignJet Plotter.

Sponsor

Donation

Did this site save
(or help earn) you money?
Say thanks with a
small donation.

Search

XML Feeds

Disclaimer

All information is presented As-Is, with no warranty. Use at your own risk. DesignJetParts.com is operated by Computer Care. One Stop for all you computer, printer, plotter and network parts and supplies
powered by b2evolution
Our Sitemaps: XML  HTML  ROR