Category: 500/510 / 800 Plotter

We often get calls into our Tech Support stating the new ISS does not look or fit like the old one. They are right, it does not. The old ISS, the C7769-60148 part number; the one the factory installed had an issue. To correct this issue the factory installed a spittoon, or “Catch Tray” under the ISS. The new part, C7769-60373 has been redesigned and does not have the same issue, so it no longer uses this “Catch Tray”. So you must remove the catch tray to install the new, updated version of the ISS. more »
Due to questions called into our shop over the years of the exact location and orientation of the Encoder Strip on the HP DesignJet 500 / 510 / 800 plotter models; we thought it was time to post some tips and photos to help you with the correct placement… more »
System error 02:10 is generated when the printer has detected a fault in the carriage assembly. This error usually appears when a print job has been sent to the printer. Causes of this error can include the trailing cable, carriage or the electronics module more »
The Encoder Strip bracket must be properly hooked on the pin or nub on the Service Station bracket, the tension from the Encoder Strip will pull against the bracket and keep it locked in place. The Encoder Strip will pass around the metal bracket from the rear side of the plotter and the two holes in the end of the Encoder Strip will be hooked over the two metal pins on the bracket. more »
There are a multitude of errors that can be traced to a dirty or damaged encoder strip.When diagnosing, troubleshooting and repairing these errors first you have to become accustomed to the errors that DesignJet plotters give when they cannot locate the carriage assembly in its travel path more »

1 2 >>

April 2018
Sun Mon Tue Wed Thu Fri Sat
 << <   > >>
1 2 3 4 5 6 7
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
29 30          
Do it yourself repair information for your HP DesignJet Plotter.

Sponsor

Donation

Did this site save
(or help earn) you money?
Say thanks with a
small donation.

Search

XML Feeds

Disclaimer

All information is presented As-Is, with no warranty. Use at your own risk. DesignJetParts.com is operated by Computer Care. One Stop for all you computer, printer, plotter and network parts and supplies
CMS software
Our Sitemaps: XML  HTML  ROR